when i select Multiple Select in container information for a container - something gets busted.

The SAVE works fine; but i can no longer go back and SAVE without being required to set a Category ( is showing and is my only option but is not a valid selection).

I have tried this with 4.7.0, 4.72, and 4.73. And have been using CVS cat module from Oct. 2.

My setup is pretty simple:

- clean install
- add one container
- hierarchy single, related terms, multiple select

- SAVE (seems ok)

- go back to edit

- simply hit SAVE again and it now says i need to enter a category; but i have none (clean install, none defined)

and, what's worse; since it won't allow me do save any edits until i do this - i can't remove the multiple select option - my only solution was to go into DB directly and fix it.

Peter Lindstrom
www.LiquidCMS.ca

Comments

liquidcms’s picture

liquidcms commented

supposed to say:

The SAVE works fine; but i can no longer go back and SAVE without being required to set a Category ( [NONE] is showing and is my only option but is not a valid selection).

but site stripped by NONE.

TheWhippinpost’s picture

TheWhippinpost commented

Witnessed.

I would find that even where there was an existing entry (made on node origination), when editing a page, the same entry-field would be empty and require, as mentioned above, inputting again.

I suspect the "required" flag is being set somehwere in the DB inadvertantly.

JirkaRybka’s picture

JirkaRybka commented
Status: Active » Closed (fixed)

This is nearly 3 years old issue. I've used 4.7.x, 5.x, and now 6.x versions of Category after the last post here was written, all without running into this problem. So I assume this was fixed long ago.